Timber Care
Timber furniture brings warmth to a home, and well-made solid timber can last for generations. Because timber is a natural material, it responds to heat, sunlight and humidity, which is worth keeping in mind through Mildura's hot, dry summers and heated winters. A few simple habits will keep your dining table, buffet or bedroom furniture looking its best.
Tips from us
- Dust regularly.
Use a soft, dry, lint-free cloth and wipe along the grain.
- Wipe up spills straight away.
Then dry the surface thoroughly. Liquid left sitting on timber can mark the finish or soak into joins.
- Use coasters, placemats and trivets.
Hot dishes, mugs and wet glasses can leave white rings in lacquered finishes.
- Keep it out of direct sunlight.
UV light changes the colour of timber: lighter timbers usually darken and darker timbers can lighten. Move placemats and ornaments occasionally so the colour changes evenly.
- Keep it away from heaters and vents.
Heaters, fireplaces, evaporative coolers and air-conditioning outlets cause rapid changes in temperature and humidity, which make timber shrink, swell and crack.
- Lift, don't drag.
Lift chairs, lamps and ornaments rather than sliding them across the surface, and put felt pads under decor.
- Protect the surface when writing.
Use a placemat or tablecloth for homework, craft and writing; pens press through paper into the finish.
- Skip silicone polishes and aerosol sprays.
They build up, attract dust and make future repairs or refinishing difficult.
- Check fittings each season.
Bolts on table legs and chair joints can loosen as timber moves through the seasons. Tighten them gently.
- Look after extension leaves.
Store spare leaves flat in the same room as the table, and use them occasionally so their colour stays close to the rest of the top.
Cleaning & Maintenance
Check your finish. Most dining tables have a lacquered (sealed) finish. Some solid timber pieces have an oiled or waxed finish, which looks more natural and needs re-oiling from time to time. Veneer is a thin layer of real timber over a stable board: care for it like a lacquered finish and never let water sit on it.
- Weekly
Dust with a soft, dry cloth, following the grain.
- As needed
Wipe with a soft cloth wrung out in warm water (add a drop of mild detergent for sticky marks), then dry immediately with a clean cloth.
- Every 6 to 12 months
Check and gently tighten leg bolts and chair joints. For oiled finishes, re-apply the oil recommended by the manufacturer when the surface looks dry or water no longer beads. Lacquered finishes don't need oiling.
- What to use
Soft cotton or microfibre cloths, warm water with a little mild detergent, coasters, placemats, trivets and felt pads, and the manufacturer's recommended oil for oiled finishes.
- What to avoid
Silicone polishes and aerosol sprays, ammonia, bleach and vinegar, abrasive cleaners and scourers, steam cleaners, wet cloths left on the surface, and plastic or rubber mats left in place for long periods, which can mark some finishes.
Spills & Accidents
Wipe up the spill immediately with a soft, absorbent cloth.
Wipe the area with a cloth wrung out in clean water to remove any residue.
Dry the surface thoroughly with a clean, dry cloth.
If a white ring or cloudy mark appears, don't sand it or use abrasives. These marks are moisture or heat trapped in the finish and can often be treated by a furniture repairer.
When to call a professional: white heat or water marks that don't fade, burns, deep scratches, lifting veneer, cracks or loose joints. Our team can advise on furniture repairs.
Important Things to Know
- Timber is a natural material.
Colour variation, grain patterns, knots and the gum veins found in timbers such as messmate and Tasmanian oak are natural characteristics, not defects.
- Timber moves with the seasons.
It expands and contracts as humidity changes. Small seasonal movement in table tops, fine gaps at joins and extension leaves fitting more tightly or loosely are normal. Mildura's very dry summer air and indoor heating can make this more noticeable.
- Colour changes in light.
Timber mellows with exposure to light. A newly exposed area, such as under a placemat or a spare extension leaf, may look different at first and usually evens out over time.
- Heat and moisture marks.
Lacquered finishes can turn white or cloudy when hot or wet items are placed directly on them.
- Rubber and plastic.
Rubber feet, plastic tablecloths and some placemats can react with certain finishes if left in place for a long time.
- Polish build-up.
Silicone and aerosol polishes leave a film that dulls the finish and can stop repair products from bonding.
Recommended Guardsman Products
Guardsman dining protection plans are available when you buy a new dining table or chairs. For everyday cleaning, a soft cloth and mild soapy water is all most timber finishes need.
-
GuardsmanPhoto coming soonProtection planGuardsman Dining Protection Collection
New dining tables, bought with the furniture. Terms apply.
$149.00
-
GuardsmanPhoto coming soonProtection planGuardsman Dining Chair Protection
New dining chairs, bought with the furniture. Terms apply.
$149.00
Guardsman cleaning and care products on their own do not include any warranty or accidental damage cover. Guardsman protection plans are separate, paid plans supplied by Guardsman Australia under their own terms, conditions and exclusions. They must be bought at the same time as your new furniture, the protector must be applied straight after delivery, and stains or damage must be reported to Guardsman within five days. Please ask us for the plan booklet before you buy. Your rights under the Australian Consumer Law are not affected.
Download this care guide
A printable PDF of this timber guide, with the same advice as this page. Easy to save on your phone or print at home.